4 responses so far ↓

• 1 Bong

  This product works well. I bought both the right and the left crown stops and it does make crown work faster. I have been an old school guy who learned to cut crown laying flat on the saw table. The past few years I have been cutting crown standing up with out stops. It still takes a good eye( or a tape measure) to set the stops.

  The stops are much easier than doing it by eye, They don’t work well on pieces much shorter than 12 inches but if you draw a pencil line or tape a line on the saw table between the stops you can still get good results.

  Only down side is they are a little expensive.

• 2 Depew

  The crown molding vice and stoppers from Hitachi are a “Don’t Bother”. They are flimsy and small only about 2 inches of support to hold the crown molding in place. It’s extemly hard to make 2 cuts the same. If you want to cut your crown molding standing up there are better options.

• 3 Aloe

  For the most part they work well except on short pieces. While not heavy duty, they get the job done. If you plan to buy the supports, also order the Hitachi 321387 Sub-fence. The price is the biggest problem, but time is money.

• 4 Brennan

  The right and left crown molding support worked great. One reviewer said it does not work at all. He must have an older version of the saw because it attached to my saw with no problem and it was easy to adjust. My only complaint is the cost. The same crown molding support for a Dewalt saw is half the price.

You must log in to post a comment.